3. Remove the air cap and soak in solvent until clean. Use a small brush
for stubborn stains if necessary. Toothpicks or small brushes may be
used to clean air passages; however, NEVER USE METAL
OBJECTS TO CLEAN PRECISELY DRILLED PASSAGES.
DAMAGED PAS- SAGES WILL CAUSE IMPROPER SPRAYING.
4. Clean gaskets with a solvent soaked rag. To prevent equipment
damage, DO NOT IMMERSE GASKETS OR SPRAY GUN BODY IN
SOLVENTS.
5. After using water to clean out water based paints or materials, spray
mineral spirits through the gun to prevent corrosion.
6. Use a non-silicone oil on all moving parts when reassembling. Use
Vaseline® or light grease on all threaded connections prior to
storage.
7. Clean and flush gun thoroughly to neutralize any contaminants
corrosive to the spray gun.
PERIODIC CLEAN-UP
Due to improper cleaning and paint it may be necessary to inspect and clean the
internal parts and the gun body.
1. Examine openings in air cap and fluid tip. If clogged, remove any o-
rings and soak the air cap or fluid tip in solvent.
2. A brush or toothpick or something similar may be used to dislodge
the dried paint from holes and pas- sages. NEVER USE METAL
OBJECTS TO CLEAN PRECISELY DRILLED PASSAGES.
DAMAGED PASSAGES WILL CAUSE IMPROPER SPRAYING.
3. Remove and check the fluid needle for excessive wear at the tip and
straightness.
IMPORTANT: If the needle tip is worn more on one side than the other, either
the needle is bent or the gun body has been dropped or knocked out-of-line.
There are no adjustments that can be made to a bent gun
Test the needle by rolling on a flat surface. Replace if necessary.
4. Check and replace any damaged o- rings and seals. O-rings and
seals can be wiped clean but not soaked in solvent.
5. Unscrew packing nuts and replace the packing ONLY if a leak will
not stop when the nut is tightened (See Figure 5). Do not over-
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce