Smarter Tools STSG-800G Návod k použití a péči Strana 1

GRAVITY FEED HVLP SPRAY GUN with Digital Micrometer Operating Manual Revision: AB Issue Date: January 2012 Manual No.: 0-SG-80

3. Turn fluid control knob fully clockwise until closed (See Figure 6). 4. Trigger a short burst while turning fluid control knob counterclockwise. O

4. The amount of paint being applied can be varied by the speed of the stroke, distance from the surface and adjustment of the fluid control knob. 5.

3. Remove the air cap and soak in solvent until clean. Use a small brush for stubborn stains if necessary. Toothpicks or small brushes may be used to

tighten a packing nut because this will restrict movement of the needle. 6. Re-assemble in reverse order of above and use a non-silicone oil on movi

LIMITED WARRANTY This information applies to Smarter Tools products purchased in the USA and Canada. January 2012 LIMITED WARRANTY: Smarter Tools™, I

GARANTÍA LIMITADA Esta información se aplica a los productos más inteligentes herramientas adquiridos en los EE.UU. y Canadá. De enero 2012 GARANTÍA

We Appreciate Your Business. Thank you and congratulations on choosing Smarter Tools. Now you can stop working harder and start working smarter. This

Operating Instructions Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product

SAFETY INSTRUCTIONS AND WARNINGS Symbol Usage This manual contains important information that you need to know and understand in order to assure YOUR

Unpacking After unpacking the product, inspect carefully for any damage that may have occurred during transit. Make sure to tighten fittings, bolts, e

WARNING! DO NOT MISUSE THIS PRODUCT. EXCESSIVE EXPOSURE TO VIBRATION, WORK IN AWKWARD POSITIONS, AND REPETITIVE WORK MOTIONS CAN CAUSE INJURY TO HAND

Introduction The spray gun is a vital link in any finishing application. In addition to operating the spray gun properly, techniques of surface prepa

used with this method. Pressure feed is generally used for spraying heavy bodied paints or for large size projects. Siphon Feed – Method of paint feed

PREPARATION 1. Thoroughly mix and thin paint in accordance with the paint manufacturer’s instructions. Most materials will spray readily if thinned p